Husqvarna BG 250 Bedienungsanweisung Seite 42

3. Lock the grinding disc or the multiflail disc and
remove the 4 bolts.
4. Remove the grinding disc or the multiflail disc from
the adapter plate.
5. Install a new grinding disc or the multiflail disc on the
adapter plate.
6. Install the 4 bolts.
7. Carefully lift the product with the handlebar to lower
the product to operation position.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
42
Do not use the dust
3. Connect the dust extractor hose to the connection
for dust extractor.
To connect the product to a power
source BG 250
1. Connect the power plug of the product to an
applicable extension cable.
2. Connect the extension cable to a mains outlet.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
To fill fuel BG 250Petrol
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
When the product is
Do not use gasoline with an
1802 - 002 - 13.04.2022