Husqvarna BG 250 Bedienungsanweisung Seite 55

• Do not use a forklift if the product is not put on a
pallet or carriage. This can cause damage to the
grinding discs and other internal components.
• During transportation, the grinding head must be
on the ground. To prevent damage to the lock
mechanism of the tool plates, keep the tool plates
installed.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below the product. Do not stay in the
product risk area. Refer to
on page 38 .
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
1802 - 002 - 13.04.2022
Be very careful when you
For ramps with a steep
Work area safety
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
1. Attach the lifting equipment at the lifting eye.
2. Lift the product safely.
To attach the product to a
transportation vehicle
The product has holes that are used with tie-down
straps to attach the product to the transportation vehicle.
55