To Replace The Blade - Husqvarna BMS 220 ADB Bedienungsanweisung

2. Loosen the lock screw (A) on the tracking controls.
A
3. Turn the tracking controls (B) counterclockwise until
they are fully open.
4. Adjust the tracking controls.
a) Turn the left tracking control 1 turn clockwise to
make the product turn to the left.
b) Turn the right tracking control 1 turn clockwise to
make the product turn to the right.
5. Tighten the lock screw on the tracking controls.

To replace the blade

WARNING:
blades are very sharp.
WARNING:
cannot start when you replace the blade.
1. Use the tool angle control to lift the tool holder from
the floor.
2. Loosen the screws on the tool holder.
3. Remove the blade.
4. Push the new blade into the tool holder.
1813 - 001 - 11.05.2022
B
Use protective gloves. The
Make sure that the product
5. Make sure that the blade is in the correct position.
6. Tighten the screws on the tool holder.
To install a chisel
WARNING:
blades are very sharp.
WARNING:
cannot start when you replace the blade.
1. Remove the blade. Refer to
page 15 .
2. Put the chisel (A) on the tool holder (B).
A
B
C
3. Install the washers and screws (C).
To sharpen the blade
WARNING:
blades are very sharp.
1. Pull the tool angle handle rearward to raise the tool
holder from the floor.
2. Sharpen the blade with an angle grinder. Use a
grinding disc with a grit of 120.
WARNING:
grinding disc does not catch the edge or
corner of the blade.
Use protective gloves. The
Make sure that the product
To replace the blade on
Use protective gloves. The
Make sure that the
15