Husqvarna BMS 220 ADB Bedienungsanweisung Seite 17

Note:
It is faster to drain the hydraulic oil if the oil is
warm.
1. Remove the oil filter cover (A).
C
A
B
2. Put a container below the oil drain plug.
3. Remove the oil drain plug (B).
4. Turn the oil filter (C) counterclockwise to remove it.
5. Remove the oil cap (D).
D
E
1813 - 001 - 11.05.2022
6. Lightly lubricate the rubber seal on the new oil filter
with new oil.
7. Attach the hydraulic oil filter. Tighten by hand until
there is resistance, then tighten ¾ turn more.
8. Install the oil drain plug when the hydraulic oil tank is
empty.
9. Fill the hydraulic tank until you can see the oil level
in the oil level indicator (E). Refer to
of the hydraulic oil level on page 16 .
10. Install the oil cap.
To do a check
17