Husqvarna BMS 220 ADB Bedienungsanweisung Seite 7

and local regulations. The dimension of the
mains socket must agree with the amperage
for the electrical socket and extension cable
of the product.
If the power mains has higher system
resistance, short voltage drop can occur
when the product is charged. This can
influence the operation of other products, for
example flicker on the lights.
• Make sure that the power, fuse and mains voltage
are the same as the voltage shown on the rating
plate of the product.
• Do not use the product if the power cord or power
plug is damaged. Hand it in to an approved service
center for repair. A damaged power cord can cause
serious injury and death.
• Use the power cord correctly. Do not use the power
cord to move, pull or disconnect the product. Pull the
power plug to disconnect the power cord. Do not pull
the power cord.
• Do not operate the product in water depths where
the equipment of the product gets wet. The
equipment can become damaged and the product
can become live and cause injury.
• Do not get more moisture into the product than
the water supplied by the water system. Keep the
product away from rain. Water that goes into the
product increases the risk of electrical shock.
• Always disconnect the power cord before you
connect or disconnect the electrical enclosure.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock if there
is a malfunction.
Do not use electrical adapters with the product.
1813 - 001 - 11.05.2022
Incorrect connection can
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
Seat belt
WARNING:
when you operate the product.
The seat belt will keep the operator in the seat in an
emergency stop.
• Keep the seat belt flat against your waist.
• Do not twist the seat belt.
• Make sure that there are no objects between you
and the seat belt.
• Do a check of the seat belt after an emergency stop.
Make sure that the function of the seat belt is correct
before you use the product.
• Keep the seat belt clean and dry.
Emergency stop button
The emergency stop button is used to quickly stop the
motor.
To do a check of the emergency stop button
Product overview BMS 220ADB on page 3 for
Refer to
information about where the emergency stop button is
on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 9 .
3. Push the emergency stop button.
4. Make sure that the motor stops.
5. Turn the emergency stop button clockwise to
disengage.
Operator Presence Control (OPC)
When the OPC is engaged, the motor stops. Refer to
To do a check of the operator presence control on page
7 .
To do a check of the operator presence control
1. Start the product. Refer to
page 9 .
Read the warning
Always use the seat belt
To start the product on
To start the product on
7