Troubleshooting; Service Data - Electrolux EH7L5DSP Benutzerinformation

Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a halogen, 230 V, 40 W, 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
Side lamp
Step 1 Remove the left shelf support to get ac‐
cess to the lamp.
Step 2 Use a Torx 20 screwdriver to remove
the cover.
Step 3 Remove and clean the metal frame and
the seal.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.

12.2 Service data

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove the rating plate from the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
Check if...
The fuse is blown.
Step 4 Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat-resistant lamp.
Step 5 Install the metal frame and the seal.
Tighten the screws.
Step 6 Install the left shelf support.
Problem
The water leaks out of
the cavity embossment.
Unsatisfying cooking per‐
formance of the function:
BakingPlus.
The lamp does not work.
.........................................
Check if...
There is too much water
in the cavity emboss‐
ment.
You filled the cavity em‐
bossment with water.
The lamp is burnt out.
ENGLISH 65