Making The Electrical Connection; General View Inverter From The Bottom - Kaco blueplanet 3.0 NX3 M2 Kurzanleitung

Lifting and installing the device
Wall bracket mounted.

1 Lift the device using the grip recesses (see Fig. 3.2). Observe the centre of gravity!
2 Hook the device into the mounting plate (see Fig. 6 and Fig. 8.2 – Pos 1.) and check that it is securely seated.
3 Mount the enclosed screws (2x M5x14mm) on both sides of the hole (Fig.8.2 – Pos 2.) to secure against lifting out.
»Device is installed. Proceed with the electrical installation.
[ P / 2 Nm]
Fig. 6: Mounting the inverter to the wall bracket
Fig. 8.1: Fasten the inverter
1.6

Making the electrical connection

NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic
conditions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
1.6.1

General view inverter from the bottom

Fig. 8.3: Connection site: Legend
A DC integrated isolator switch
B DC connector for PV generator
C COM1&2 – RJ45 socket for RS485 connection F
KACO blueplanet 3.0 NX3 M2 KACO blueplanet 5.0 NX3 M2 KACO blueplanet 8.0 NX3 M2 KACO blueplanet 10.0 NX3 M2
KACO blueplanet 15.0 NX3 M2 KACO blueplanet 20.0 NX3 M2
Fig. 7: Check that the device is secure.
Fig. 8.2: Securing the inverter
D COM 3 – Connector for WiFi stick
E AC connection socket
Housing grounding
Page 7