Led Light; Power Adapter; Li-Ion Battery - VOLTCRAFT 2304480 Bedienungsanleitung

c) LED light
Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
d) Power adapter
1
• Connect the appliance to a wall socket that can be accessed easily.
• As power supply, only use the supplied mains adaptor.
• Only connect the power adaptor to a normal mains socket connected to the public supply. Before
plugging in the power adaptor, check whether the voltage stated on the power adaptor complies with the
voltage of your electricity supplier.
• Never connect or disconnect power adaptors if your hands are wet.
• Never unplug the power adaptor from the mains socket by pulling on the cable; always use the grips on
the plug.
• For safety reasons, disconnect the power adaptor from the mains socket during storms.
• Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric shock!
Take the following steps:
• Switch off the mains voltage to the socket containing the power adapter (switch off the corresponding
circuit breaker or remove the safety fuse, and then switch off the corresponding RCD protective switch).
• Unplug the power adapter from the mains socket.
• Use a new power adapter of the same design. Do not use the damaged adapter again.
• Ensure that cables are not pinched, kinked or damaged by sharp edges.
• Always lay cables so that nobody can trip over or become entangled in them. This poses a risk of injury.
e) Li-ion battery
• The rechargeable battery is permanently built into the product and cannot be replaced.
• Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might cause
an explosion or a fire!
• Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product into
fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you do are not using the product. Due to the
rechargeable battery technology being used, you do not need to discharge the rechargeable battery first.
• When charging, place the product on a surface that is not heat-sensitive. It is normal that a certain
amount of heat is generated during charging.
48
Do not tamper with power supply components. Risk of death by electric shock!
- Always ensure proper connection.
- Never use damaged power supply components.
- Do not modify power supply components.