Miele PW6 7 Serie Umbau- Und Montageanweisung Seite 23

M.-Nr. 09087201
Sign on module
A Main menu
Select Service level >
A
To save, confirm with the OK  button.
A
Main menu
In the Service level >
On
value to .
A
Press the Back button to go back one level.
A
To save, confirm with the OK  button.
 The operator can use the switched-on dispenser display to select and deselect dispensing. Without a dispenser
display, only the program determines whether and how much is dispensed.
Performing data backup via service mode
A Main menu
Select Service level >
A
To save, confirm with the OK  button.
 EW data is overwritten and a backup is created.
Exiting the service level
A
To exit the service level, switch off the machine.
Connecting and calibrating the dispenser pump
A
Break out the pre-punched area in the machine rear panel; see Fig. 3.
A
Install the cable feed-through on the machine rear panel; see Fig. 3.
A
Connect the dispenser pumps in accordance with the wiring diagram.
A
If the flow rate of the dispenser pumps is known, enter the flow rate directly in the supervisor level (example:
dispenser pump 1).
A
To enter the flow rate, select the
menu.
A
Enter the flow rate in the
A
Confirm with the OK button.
A
Press the Back button to go back one level.
A
To save, confirm with the OK  button.
A
If the flow rate of the dispenser pumps is not known, calibrate the dispenser pumps in the supervisor level
(example: dispenser pump 1).
A
Supervisor level
Select the
A
Place the suction wand of the dispenser pump in a container with a fill line.
A
Fill the container to the fill line.
A
Press button 0/1 (dispenser pump runs for 60 s).
A
Use a measuring vessel to refill the container up to the fill line.
A
Determine the dispensing quantity in the measuring vessel and enter it on the display for the
value.
A
To save, confirm with the OK  button.
A
To register a container empty signal (example: dispenser pump 1), select the
Dispenser level reminder
>
A
Set the parameter value to
A
Confirm with the OK button.
A
Press the Back button to go back one level.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Service settings
>
Service settings
>
Backup Backup data to EW
> >
Supervisor level Main menu
>
.....ml/min
parameter value.
Main menu Settings
> > >
Dispenser pump 1
> menu.
Yes .
Umbau- und Montageanweisung
Sign on module EZL with coding 3
> >
Basic setting Dispensing
> >
Overwrite existing data?
>
Settings Dispensing flow rate
> >
Dispenser calibration Dispenser pump 1
>
Supervisor level
Sign on module?
>
Dispenser display
, set the
.
Dispenser pump 1:
>
menu.
V:.....ml
parameter
Main menu
>
23 von 54
.
parameter
Settings
>
20.01.2022