Installation; Electrical Installation - Dometic Oceanair Skyscreen Powered Montage- Und Bedienungsanleitung

Skyscreen Powered
7

Installation

!
WARNING! Risk of injury
Disconnect the power supply before you begin and ensure that it can not be
reconnected until installation has been completed.
7.1

Electrical installation

The electrical power supply must be connected by a qualified electrician who
has demonstrated skill and knowledge related to the construction and opera-
tion of electrical equipment and installations and has received safety training to
identify and avoid the hazards involved.
The powered blinds are available for a connection to a 12/24 Vg power supply.
The data plate on the head rail provides important information on the specifica-
tions of the motor.
The following notes must be observed when connecting the blinds:
• Ensure cables are not damaged during installation. Routings of cables
through walls or bulkheads must be protected and insulated by appropriate
bushing, grommets or cable conduits.
• Ensure that a 12 V or 24 V stabilized power supply line is available for the
drive at the point of installation. The power supply line is suitably arranged
and protected.
• Secure all cables to prevent any contact with moving parts.
• Only use power supply units and control elements recommended by the
manufacturer to prevent damage or faults during operation caused by incom-
patible electrical components.
• Control devices (e.g. switches) must be installed in visible locations.
➤ Connect the motor as shown in the wiring diagrams:
– Dometic radio controlled blind internal receiver (fig. 6, page 5)
– Dometic radio controlled blind external receiver (fig. 7, page 6)
– Manually switched blind (fig. 8, page 6)
– Somfy radio controlled blind external receiver (fig. 9, page 6)
– Somfy radio controlled blind internal receiver (fig. 0, page 7)
EN
Installation
13