Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Use ductwork or cable ducts if it is necessary to
lay cables through metal panels or other panels
with sharp edges.
• Fasten the cables securely.
• Do not pull on the cables.
Safety precautions when handling
batteries
!
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Risk of injury
• Batteries contain aggressive and caustic acids.
Avoid battery fluid coming into contact with
your body. If your skin does come into contact
with battery fluid, wash that part of your body
thoroughly with water.
If you sustain any injuries from acids, contact a
doctor immediately.
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Risk of injury
• When working on batteries, do not wear any
metal objects such as watches or rings.
Lead acid batteries can cause short circuits
which can cause serious injuries.
• Wear goggles and protective clothing when you
work on batteries. Do not touch your eyes when
you are working on batteries.
Explosion hazard
• Do not smoke, use an open flame, or cause
sparking near the engine or a battery.
A
NOTICE! Indicates a situation that, if
not avoided, can result in property
damage.
• Prevent any metal parts from falling on the bat-
tery. This can cause sparks or short-circuit the
battery and other electrical parts.
• Ensure that the polarity is correct when connect-
ing the battery.
• Follow the instructions of the battery manufac-
turer and those of the manufacturer of the system
or vehicle in which the battery is used.
• If you need to remove the battery, first discon-
nect the ground connection. Disconnect all con-
nections and all consumers from the battery
before removing it.
6
Safety precautions when handling
lithium batteries
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Risk of injury
• Only use batteries with integrated battery man-
agement system and cell balancing.
A
NOTICE!
Damage hazard
• Only install the battery in environments with an
ambient temperature of at least 0 °C.
Scope of delivery
Qty.
Description
1
MT iQ Control display
1
Wall-mounting box
1
Hall sensor
1
Control module with a 6 pin connector and
mounting plate
1
Data cable, control module to display
1
Pack of 10 screws
6
Wiring for the control module
1
High current ground cable, 80 cm (Black)
2
High current positive cable, 40 cm (Orange)
1
High current fuse holder with fuse 175 A
2
Battery terminal cover
1
LiFePO4 battery (Depending on the Power
Unit set 85 Ah, 105 Ah, 120 Ah or 180 Ah)
2
Battery terminal adapter (Power Unit 85 and
105 sets only)
1
Installation and Operating Manual
Accessories
Description
Extension data cable
(5m)
4445103614
SKU
9620000268 (MT01218)
Werbung
Inhaltsverzeichnis
Fehlerbehebung
