Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6.6
Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.7
Fitting or removing the guard
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
▶ Observe the instructions for fitting the applicable guard.
6.7.1
Fitting the guard
The guard has coded locating lugs to ensure that only a guard suitable for use with the product can
be installed. The coded locating lugs of the guard fit into the guard mount on the product.
1. Fit the guard on to the arbor collar so that the two triangular marks on the guard and on the product are
in alignment.
2. Press the guard on to the drive spindle collar.
3. Press the guard release button.
4. Rotate the guard until it engages and the guard release button jumps back into its original position.
6.7.2
Adjusting the guard
▶ Press the guard release button and then rotate the guard until it engages in the desired position.
6.7.3
Removing the hood
1. Press the guard release button and turn the guard until the triangular marks on the guard and on the
product are in alignment.
2. Remove the guard.
6.8
Fitting or removing the front cover
The front cover, when used, is clipped onto the guard.
1. Position the front cover with the closed side on the standard guard and push it on until it engages.
2. To remove it, release the catch for the front cover and then lift the front cover away from the standard
guard.
6.9
Positioning the DC-EX 125/5"C dust hood (for cutting)
▶ Position the compact guard so that the on/off switch remains easily accessible and operable at all times.
*2272031*
6
7
2272031
8
English
33
Werbung
Inhaltsverzeichnis
