Hilti AG 5D-22-125 Original Bedienungsanleitung Seite 38

3.9.2 Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three
seconds. The system does not detect a potential malfunction of the battery due to misuse, for example
battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
4 Consumables
Use only synthetic resin-bonded, fiber-reinforced wheels with a maximum Ø of 125 mm (5") approved for a
rotational speed of at least 11000 rpm and a peripheral speed of 80 m/s.
The maximum permissible grinding wheel thickness is 6.4 mm and the maximum permissible cut-off wheel
thickness is 3 mm.
ATTENTION! When cutting or slitting with abrasive cut-off wheels always use the standard guard with
the additional front cover, or a fully enclosing dust hood.
Wheels
Type
Abrasive cut-off wheel
Diamond cut-off wheel
Abrasive grinding wheel
Diamond grinding wheel
Wire brush
Diamond core bit
Abrasive resin-fiber wheel
Suitability of wheels for the equipment used
Item Equipment
A Guard
B Front cover (in
combination with
A)
C Dust hood (grinding)
DG­EX 125⁄5"
D Dust hood (cutting)
DC­EX 125⁄5"C (in
combination with A)
E Side handle
F Clamping nut
G Clamping flange
30 English
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
Application
Cutting, slitting
Cutting, slitting
Rough grinding
Rough grinding
Wire brushes
Drilling in tiles
Rough grinding
AC­D AG­D, DG-CW
AF­D, (SPX, SP,
AN­D
X X
X —
— —
— —
X X
X X
X X
Designation Material
AC­D Metal
DC-TP, DC­D (SPX, Mineral
SP, P)
AG­D, AF­D, AN­D Metal
DG­CW (SPX, SP, Mineral
P)
3CS, 4CS, 3SS, Metal
4SS
DD­M14 Mineral
AP-D Metal
DC-TP, AP-D
DC-D
P) (SPX, SP,
P)
X X
— X
X —
— X
X X
X X
X X
2272031
*2272031*
3CS, 4CS,
3SS, 4SS,
DD-M14
X X
— —
— —
— —
X X
— —
— —