Automatic Position Search; Balancing Programmes - TECO 680 Original Anleitungen

A special safety device stops rotation if the guard is lifted up during the spin; in this case,
the A Cr message is displayed.
CAUTION
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
CAUTION
Never raise the guard before the wheel has come to a stop.
CAUTION
If the wheel keeps spinning permanently due to a fault on the machine, switch off the machine
using the main switch or disconnect the plug from the power supply board (emergency stop)
and wait until the wheel stops before raising the guard.

aUTomaTiC PoSiTion SEarCH

During position search, the wheel can rotate with the guard raised. Each time the Start
1
S TART
button is pressed, you pass from the centred position of one side to that of the
other side. This function is active only if the RPA programme is set to ON (see " Auto-
matic position search configuration (RPA)", a function present in the configuration pro-
grammes).
This programme may also be performed by pressing buttons
ously. This function is used in particular on machine versions WITHOUT the wheel guard.

BalanCing ProgrammES

before starting a balancing operation, the following steps must be followed:
- mount the wheel on the hub using the most suitable centring system;
- make sure that the wheel is locked correctly to the shaft so that no displacement can
occur during the spin and braking phases;
- remove any counterweight, pebble, dirt or other foreign body;
- set the wheel's geometric data correctly.
The balancing programmes are grouped within the Balancing programme icon in the
main working screen.
Select the icon
Each time it is pressed, the machine automatically changes the type of balancing pro-
gramme (as shown on the graphic on the video) in the following sequence:
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
and press the keypad Enter
0
1
STOP
S TART and simultane-
button.
EN
91