Utility Programmes - TECO 680 Original Anleitungen

or at the centre of the rim well, indifferently. If applied in the well, the weight is applied
on a diameter smaller than the rated diameter of the rim. A value of 2 or 3 inches less
than the rated value must therefore be entered when the diameter is set in order to
obtain correct results.
best results can be achieved if the weight is divided into two parts to be applied on the
two sides of the rim.

UTiliTY ProgrammES

The Utility programmes are all the functions of the machine that are useful for its opera-
tion but are not strictly connected to its normal operation.
Select the Utility and configuration programmes icon to display the list (menu) of the
utility programmes
This wheel balancer allows three operators to work at the same time thanks to three
different working environments.
- Select the Working environments icon to call up a different working environment.
- The following icons are displayed:
The lit icon shows the operator selected.
- Press the Enter button to select the icon desired
- Press the Exit button to save the setting and exit
- The selection can also be seen in the working screen status line.
by selecting a new operator, the machine resets the parameters that were active at the
last recall.
The stored parameters are:
- balancing mode; dynamic, ALU, motorcycle, etc.
- wheel dimensions: distance, diameter and width or those relating to the active ALU programme;
- OPT: last OPT.
The machine's general settings remain the same for all working environments: grams/
ounces, sensitivity x5/x1, threshold, etc....
102
.
Working environment programme
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.
.