Configuration Programmes; Selection Of Adhesive Weights Application Position - TECO 680 Original Anleitungen

- Select the icon;
- press enter to open or close the automatic locking system PL.
This function can be inserted in the bar of the main icons, as explained in Preferred
programme confi guration.

ConFigUraTion ProgrammES

EN
The Confi guration programmes are those functions that are intended for customising the
machine's operation and are normally executed when the machine is installed.
The list of the confi guration programmes can be displayed as follows:
- select the utility and confi guration programmes
icon;
- select the confi guration programmes icon .
Automatic Position Search (RPA) Confi guration
Enables/disables the automatic positioning of the wheel at the end of the spin. After the
list of the setting programmes is displayed, proceed as follows:
- Select the Automatic position search confi guration icon .
The following icons are displayed:
RPA OFF; disables the automatic position search procedure.
RPA ON; enables the automatic position search procedure.
- Press the Enter button to select the icon desired
.
- Press the Exit button to save the setting and exit .
The selection can also be seen in the working screen status line.

Selection of adhesive weights application position

To access this programme you must:
- select the Utility programmes icon;
- select the Confi guration programmes icon.
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
109