Error Messages - TECO 680 Original Anleitungen

display this programme
This program is used to optimise the synchronisation of the LCD motor approved by the
manufacturer. Proceed as follows to perform this synchronisation:
- select the
- once selected, the following screen will appear on the monitor;
- to perform the synchronisation, press
the corresponding key directly on the
LCD monitor (read the instructions in the
monitor user manual).
Push the exit key
without performing the synchronisation.
IMPORTANT:
repeat the operation if necessary if syn-
chronisation was not successful.
The machine can recognise a certain number of malfunction conditions and signals them
by displaying the relevant messages.
A 3 Wheel not suitable for performing the sensitivity calibration, use a wheel of
average dimensions (typically 5.5"X14") or larger, but NOT exceeding a weight
of 40kg.
A 5 Incorrect dimension settings for an ALU programme. Correct the set dimensions.
A 7
The machine is temporarily unable to select the requested programme.
Perform a wheel spin, then repeat the request.
A 20 Sensor in an incorrect position during calibration.
bring it to the position indicated and repeat the calibration.
A 20 Ultrasonic sensor calibration template in an incorrect position during calibration.
bring it to the position indicated and repeat the calibration.
A 26 Programme available only after selecting one of the following programmes:
ALU 1P / ALU 2P / Motorcycle Dynamic / Motorcycle ALU or if selected in the
Motorcycle Programme but with the wheel NOT in the centred position.
A 31 Optimisation procedure (OPT) already launched by another user.
A 41
Incorrect wheel spin procedure on the wheel balancer without guard. The warn-
118
.
monitor auto Setting
MONITOR AUTO SETTING icon;
to exit the program

Error mESSagES

– A – Notice Messages
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl