Hilti Nuron AG 6D-22-125 Original Bedienungsanleitung Seite 43

As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap as described in the section headed Installing Hilti retaining strap → page 34.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6.6 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.7 Fitting or removing the guard
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
▶ Observe the instructions for fitting the applicable guard.
6.7.1 Installing the guard (standard)
The guard is keyed to ensure that only guards of a type suitable for use with the product can be
installed. The locating lugs of the guard fit into the guard mount on the product.
1. Fit the guard on to the arbor collar so that the two triangular marks on the guard and on the product are
in alignment.
2. Press the guard on to the drive spindle collar.
3. Press the guard release button and turn the guard until it engages in the desired position.
▶ The guard release button jumps back.
6.7.2 Adjusting the guard (standard)
▶ Press the guard release button and then rotate the guard until it engages in the desired position.
6.7.3 Removing the guard (standard)
1. Press and hold down the guard release button and turn the guard until the triangular marks on the guard
and on the product are in alignment.
2. Remove the guard.
6.8 Fitting or removing the front cover
The front cover must be in position on the standard guard.
1. Position the front cover, with the closed side facing up, on the standard guard.
▶ The lock must engage with an audible click.
2. To remove, open the lock of the front cover.
3. Remove the front cover from the standard guard.
6.9 Fitting and removing accessory tools
CAUTION
Risk of injury. The accessory tool may be hot.
▶ Wear protective gloves when changing the accessory tool.
*2233921*
8
9
2233921 English 35