Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Connecting the electricity
Life-threatening danger from electric shock!
Improper assembly and installation of the device can lead to life-threatening electrical
WARNING!
voltages.
−
Only allow a qualified electrician to install and connect the device.
Personnel:
•
Qualified electrician
Materials:
•
DIN rail (15 mm x 7.5 mm)
•
DIN rail (15 mm x 12.5 mm)
Prerequisite:
•
The terminals for the wires must have a cross-section between 0.5 mm² and 2.5 mm².
Fig. 4: Installation on a DIN rail
1.
Place the clock timer on the DIN rail (Fig. 4) from above and press it back until it locks into place.
2.
Strip the insulation from the wires.
•
Stripping length: 8 mm
Tightening torques
To avoid damage and faulty contacts, tighten the terminals using a torque of 0.5 Nm.
NOTE!
EN
73
Werbung
Inhaltsverzeichnis
