Operating modes
Automatic mode
EN
In automatic mode, the channel is switched on or off based on the programmed switching times.
For the description, see Chapter "Creating a new automatic switching program" on page 97
Pulse mode
In pulse mode, the channel is switched on or off in short, programmed pulses (1 – 60 seconds).
For the description, see Chapter "Creating a new pulse switching program" on page 103
Cycle mode
In cycle mode, the channel is switched on or off in a cyclically recurring program.
For the description, see Chapter "Creating a new cycle switching program" on page 100
Permanently ON
Channel is permanently switched on.
For the description, see Chapter "Permanently ON" on page 85
Permanently OFF
Channel is permanently switched off.
For the description, see Chapter "Permanently OFF" on page 86
Override mode
In override mode, the current program is temporarily overwritten. The override function only applies to
the current program and remains active until the next automatic command. Then the device returns to
automatic mode.
For the description, see Chapter "Override mode ON/OFF" on page 86
68