Approved Mode; Weighing Units - OHAUS PR-Serie Bedienungsanleitung

EN-20

5.3.11 Approved Mode

Use this menu to set the Legal for Trade status.
OFF = standard operation.
ON = operation complies with Legal Metrology regulations.
For PRxxxN models:
Use this menu to set the Legal for Trade status.
OFF = standard operation.
ON 1d = operation complies with Legal Metrology regulations, e=1d
ON 10d = operation complies with Legal Metrology regulations, e=10d
Note: When Approved Mode is set to On, the menu settings are affected as follows:
Calibration Menu:

For InCal models, only Internal Calibration is available. All other functions are hidden.

For ExCal models, the entire Calibration menu is hidden.
Balance Setup Menu:

Filter Level is locked at the current setting.

Auto Zero Tracking is limited to 0.5 Division and Off. The selected setting is locked.

Auto Tare is locked at current setting.

Graduations are forced to 1 Division and the menu item is hidden.
Communication Menu (Communication->Print Settings->Print Output):

Stable Weight Only is locked On.

Numeric Value Only is locked Off.
Communication Menu (Communication->Print Settings->Auto Print):

Auto print mode selections are limited to Off, On Stability, and Interval. Continuous is not available.
Lockout Menu:

Menu is hidden

5.4 Weighing Units

Enter this sub-menu to activate the desired units of measure.
PR balances provide a choice of 12 units, which are all set On by default.
Note: Due to national laws, the balance may not include some of the units of measure listed below.
NTEP model: The Unit menu is used to enable or disable a specific unit. (SET ON, SET OFF).
Unit
Gram
Kilogram
Milligram
Carat
Pound
Ounce
Ounce Troy
Penny weight
Newton
Grain
TW Tael
Custom 1
Display
g
kg
mg
ct
lb
oz
ozt
dwt
N
GN
t
C
PR Series Balance
LFt
LFt