Radio-Controlled Operation; Meaning Of The Leds On Pp 45 Rc; Radio Components Which Can Be Taught-In (Eep) - Maico PP 45 O Installations- Und Inbetriebnahmeanleitung

11 Radio-controlled operation

11 Radio-controlled operation
Radio-controlled operation (EnOcean) is imple-
mented as follows:
• Purely radio-controlled system
DS 45 RC + PP 45 RC / PP 45 RC / PPB 30
RC ...
• Combination system
RLS 45 K + max. 6 PP 45 K / PP 45 O or
RLS 45 K+ max. 3 PPB 30 O / PPB 30 K
• Combination system
PP 45 EO + PP 45 RC / PPB 30 RC
Further characteristics
• For range of radio components → Technical
data [} 37].
• For possible radio combinations → Overview
figures of control concepts.
• The radio mode (EnOcean) is activated by the
specialist installer. Once radio operation has
been activated, you can teach-in/delete
EnOcean radio components directly on the
ventilation unit.
The teach-in process is described in detail in
the operating instructions. It must be read be-
fore you proceed with teaching-in.
11.1 Meaning of the LEDs on PP 45
RC/PPB 30 RC
LED
Orange
Blue
Red
48
Meaning
LED flashes x times
when the heat recovery
operating mode is se-
lected (x = selected
ventilation level). When
demand-driven opera-
tion is selected, the
LED lights up for
5 seconds.
LED flashes x times
when the cross-ventila-
tion mode is selected (x
= selected ventilation
level). When demand-
driven operation is se-
lected, the LED lights
up for 5 seconds. In ex-
haust air mode (PPB 30
RC), the LED lights up
2x for 2 seconds.
Filter change display
and fault indicator light.
11.2 Radio components which can be
taught-in (EEP)
PP 45 / PPB 30 radio components must support
the EEP protocol. The radio components can be
combined with the EEP specified below.
Type
DS 45 RC radio switch, 4-chan-
nel wall transmitter
Humidity/temperature sensor*
CO2/temperature sensor
VOC/temperature sensor**
PP 45 ACT: 1-channel recessed-
mounted switch
* Not available for PPB 30 units.
** No EnOcean VOC sensor currently available.
If within range, up to 8 radio sensors can be
used with radio-controlled systems.
Radio actuator PP 45 ACT (1 channel): The
PP 45 Act can be used to activate the "Supply
air for exhaust air units" function for PP 45 RC
units. The PP 45 ACT is connected and taught-
in in accordance with the enclosed installation
and operating instructions.
Teaching-in tips
• Radio components are taught-in directly on the
RC-Master (TEACH key).
• Only one slave unit can be assigned to each
master ventilation unit of the same type. Excep-
tion: In systems with PP 45 RC and PPB 30 RC
unit pairs, the additional teaching in of the PPB
30 RC into the master PP 45 is possible.
• Correct operation of a unit pair is monitored by
the master unit.
• Teach-in mode is deactivated each time a radio
component is saved, meaning that it has to be
called up again for each further component.
• If nothing is received within 120 seconds, the
teaching-in process is ended (the LED on the
ventilation unit switches off).
• Teach-in telegrams from non-supported units
are ignored.
EEP
F6-02-01
A5-04-01
A5-09-08
A5-09-05
D2-01-01