Heating The Sauna Room; Using The Sauna Climate Device - Saunum Professional Bedienungs- Und Installationsanleitung

200 mm
50
mm
* *
* *
The temperature sensor can be located
on either side of the heater. It is not recom-
mended to place the temperature sensor
near or on the inside corner, the venti-
lation inlet, or near the door/glass wall, as
this may provide an incorrect temperature
indication when heating the sauna room
with the device.
NB! The maximum temperature at the height of the temperature sensor of the controller
(200 mm from the heater and 50 mm from the ceiling) is 100 °C (Figure 1).
12
200 mm
50
mm
Figure 1
HEATING
THE SAUNA ROOM
Before using the sauna climate device for
the first time, make sure that:
• the electrical connections meet the
requirements;
• the supply voltage corresponds to
the nominal ratings allowed for the
sauna climate device;
• the protective earth (PE) is in work-
ing order;
• the attachments of the sauna cli-
mate device housing are in order;
• the sauna climate device is pro perly
attached to the wall;
• the over-current fuses are in working
order;
• the fan rotor rotates smoothly;
• there are no tools or materials left
after mounting the device in the
housing.
When switching the sauna climate device
on, check:
• the direction of the air flow – the air
intake from the upper and the out-
put from the lower opening;
• that there is no vibration or excessive
noise when the fan is running.
When the sauna climate device is switched
on for the first time, the heaters and the
stones will emit an odour. The sauna room
must be properly ventilated to remove the
odour.
If the power of the heater is suitable for
the sauna room, it takes 45 to 90 minutes
to reach the desired temperature in a pro-
perly insulated sauna room. The stones are
usually heated to the steam temperature
at the same time as the sauna room. Only
switch the device fan on just before enter-
ing the sauna room – this will help to pre-
vent the sauna bench from overheating
and an excessive energy consumption.
Saunum's recommended temperature
for sauna experience is 65 ° to 80 °C.
USING THE SAUNA
CLIMATE DEVICE
NB! Before switching the sauna climate de-
vice on, always make sure that nothing is
above or near the device.
The operating time of the sauna climate
device model Sauna Professional may be
adjusted by a separate control device.
• Do not connect the device directly to
the mains!
• The sauna climate device must not
be used if the components of its
housing have been removed and/
or the wiring diagram has been
changed.
• Children should not be allowed to
access or play with the sauna climate
device.
13