Lionelo Bastiaan RWF Bedienungsanleitung Seite 14

See: fig. 15.
1.
Place the child safety seat on the car seat, put the child in it.
2.
Pull the shoulder belt of the car through the shoulder belt guide (A) on the headrest.
3.
Pull the hip part of the car belt through the hip belt guide (O) at the seat. Carry the
shoulder belt through the same guide.
4.
Fasten the belts.
5.
Tighten the car belt.
Make sure the shoulder part goes through the child's collarbone, not its neck. The hip part
must be as low as possible in relation to child's hip.
B. HOW TO ASSEMBLE WITH ISOFIX SYSTEM AND TOP TETHER OR ISOFIX, TOP
TETHER + CAR SEAT BELTS
GROUPS 0, I (0 – 18 kg)
Installation in a rear-facing position.
See: fig. 16 and 17.
1.
Place the child safety seat on the car seat.
2.
If necessary, put both ISOFIX pads (Z1) on fixing points of your car. Press ISOFIX buttons
(Z) to pull out the connecting arms (Y). Pull them out as far as possible and then connect
to fixing points of your car. After you have heard a „click", press the child safety seat
against the car seat. ISOFIX latch indicators should be green on both ISOFIX arms (fig. 16).
3.
Pull TOP TETHER fixing belt out and next extend it with the use of the adjustment (X).
Fasten the handle in the spot suggested in the vehicle manual (see: fig. 17). Tighten
TOP TETHER with the use of the adjustment (X). The upper fixing belt is properly
tightened when you can see a green indicator in the buckle.
Note
- the upper belt fastening point can differ, depending in the car. The figure 17 shows
examples of fixing, depending on the car model.
GROUP I (9 – 18 kg)
Installation in a forward-facing position.
1.
Place the child safety seat on the car seat.
2.
If necessary, put both ISOFIX pads (Z1) on fixing points of your car. When you can
hear a „click", press the child safety seat against the car seat as much as you can. Press
ISOFIX buttons (Z) to pull out the connecting arms (Y). Pull them out as far as you can,
and then connect to fixing points of your car. ISOFIX latch indicators should be green
on both ISOFIX arms (fig. 18)
3.
Pull TOP TETHER fixing belt out and next extend it with the use of adjustment (X).
Fasten the handle in the spot suggested in the vehicle manual (see: fig. 19). Tighten
TOP TETHER with the use of the adjustment (X). The upper fixing belt is properly
tightened when you can see a green indicator in the buckle.
Note
– the upper belt fastening point can differ, depending on the car. The figure 19 shows
examples of fixing, depending on the car model.
EN ‑ 14 ‑