1. Disconnect the appliance from the power supply (unplug).
2. Slightly tilt the appliance back and secure it in this position. Do not tilt the
appliance more than 45°!
3. Remove the screws (1) and then the top metal-panel (6). Now remove the
door. Put the door on a soft surface to avoid scratches. A second person
should assist you.
4. Unscrew the top hinge axis (5) from the top panel. Now screw the axis to
the left side of the cover panel (6)
5. To remove the bottom hinge (2) remove the two screws (8).
6. Now unscrew the left front foot (4) and fix it on the opposite right side.
7. Move the complete bottom hinge (2) together with the other hinge axis (7)
to the opposite left side and fix it with the two screws (8). Also install the
other front foot.
8. Place the door carefully on the hinge axis (7) of the bottom hinge. Keep the
door properly adjusted. A second person should assist you.
9. Place the hinge axis (5) of the top metal-panel (6) into the corresponding
device of the door and fix the adjusted panel with the screws (1).
10. Finally check if the door is properly adjusted an can be properly closed.
Figure 1: before changing
Installation of the decor-frame
1. Place the décor-panel (1) against the surface of the door of the appliance (2).
Take the bottom-part (3) of the decor-frame to clasp the bottom of the
decor-panel (1) with the four screws (4).
How to change the hinge position:
Figure 2: after changing
34