GB
5.
Guide rall
6.
Fixing bolt / mitre gauge
D
7.
Knob / mitre gauge
8.
Mitre fence
9.
Blade guard
NL
10. Back Fence ( central end with 45° cutting)
11. Back Fence (double end planed)
12. Locking knob (for stop head moving)
F
13. Clamps for water reservoir
2. SAFETY INSTRUCTIONS
E
Explanation of the symbols
P
Read instructions carefully.
I
In accordance with essential applicable safety standards of European directives.
S
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
SF
Indicates electrical shock hazard.
N
Immediately unplug the plug from the mains electricity in the case that the cord gets
damaged and during maintenance.
DK
Wear ear and eye protection.
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
Specific safety instructions
•
Wear protective glasses, dust mask, ear defenders, work gloves and protective-sliding shoes.
•
Keep the table flat an d do not scratch or press the table.
•
Do not put hands anywhere near the blade whilst it is rotating.
•
Do not attempt to free a jammed blade without first switching off or removing the plug from
the mains power supply.
•
Do not cut small workpiece and also do not use for a purpose not intended.
•
Keep water full in the tank when you operate the cutter.
•
Do noy use any solvents for instead water in this tool.
•
Maintain th tool with care, keep blade sharp and clean, inspect plug, cord and water hose
periodically.
4
Ferm
Ferm
GB
D
NL
F
E
P
I
S
SF
N
DK
77