Operating The Tool - Ferm Tcm1007 Gebrauchsanweisung

GB
Installing the stand
Fig.1
D
• Assemble the four legs to the table.
• Take care to tighten the bolts firmly, so that the machine stands securely.
• Place the water reservoir in the table, and secure it in place using the two clamps (13, Fig. 1).
NL
• Place the machine in the water reservoir.
Connecting to the power supply
F
Check that the power supply and plug used in accordance with tour tool. Have a look at the
rating plate on the tile cutter. Any changes should always be carried out by a qualified
electrician.
E
We strongly recommend the use of an RCD (Residual Current Device) of not more
than 30 mA, at the plug socket when using this appliance.
P
Warning! This machine must be earthed.
I
If not properly earthed this machine can cause an electrical shock. Be sure that the power
S
supply outlet is earthed. If there is any doubt, have it checked by a qualified electrician.
Warning! Avoid contact with the terminals on the plug when installing (removing) the
SF
plug to (from) the power supply outlet. Contact will cause a severe electrical shock.
N
Using an extension lead
The use of any extension lead will cause some loss of power. To keep this to a minimum and to
DK
prevent overheating and motor burn-out, ask advice from a qualified electrician to determine
the minimum wire size of the extension lead.
The extension lead should be equipped with an earthed type plug that fits the power supply
outlet at one end, and with an earthed type socket that fits the plug of the machine at the other
end.

4. OPERATING THE TOOL

Read and understand the following items about your tile cutter before attempting to
use the machine.
Fig.1
• Adjust the required tool position, then tighten all the adjusting knobs, fence bolts and mitre
gauge bolts.
• Release the locked knob (12, Fig.1).
• Turn on the main switch and allow your tool to reach the maximum speed before
commencing cutting.
• Hold the workpiece firmly against the work table and fence, then feed machine smoothly
and evently to the workpiece.
6
CE KONFORMITETSERKLÆRING (DK)
Vi erklærer herved, udelukkende på eget ansvar, at dette
opfylder følgende standarder eller standardiserede dokumenter:
EN61029-1, prEN61029-2-7, EN12418, EN60825-1, EN55014-1, EN55014-2,
98/37/EC, 73/23/EEC, 89/336/EEC, 2002/95/EC, 2002/96/EC
Fra 01-01-2006
ZWOLLE NL
J.A. Bakker - van Ingen
CEO Ferm BV
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor til
enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
Ferm Ferm
FRTC-600
EN61000-3-2, EN61000-3-3
i overenstemmelse med direktivreglerne
J. Lodewijk
Quality Manager Ferm Global
GB
D
NL
F
E
P
I
S
SF
N
DK
75