Installation - Ferm TCM1007 Gebrauchsanweisung

GB
D
NL
F
E
P
I
S
SF
N
DK
76
• Disconnect the tool from power source when not in use or before servicing. Changing the
accessories must be carried out by qualified person.
• Ensure to locked tool head (12, Fig.1), before storing it.
• When not in use, the tool must be stored in a dry place.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country
to reduce the risk of fire, electric shock and personal injury. Read the following safety
instructions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating plate.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
PRCD
Portable residual current device
Connection to water supply
1) For tools intended to be connected to a water supply, instructions for the connection to the
water supply, the use of the water and the use of attachments to comply with 14.5 in order to
avoid affection of the tool by water, the inspection of hoses and other critical parts which
could deteriorate and the maximum permitted pressure of the water supply.
2) For tools intended to be connected to a water supply, the substance of the following
instructions, if applicable:
• For tools provided with a PRCD: Never use the tool without the PRCD delivered with
the tool,
• For tools provided with an isolating transformer: Never use the tool without the
transformer delivered with the tool or of the type as specified in these instructions,
• Replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organisation,
• Keep water clear off the electrical parts of the tool and away from persons in the
working area.

3. INSTALLATION

Assembly
Warning! Never connect the plug to power source outlet until all installations and
adlustments are completed and tou haven read and understood the safety and
operational instructions.
Ferm Ferm
GB
D
NL
F
E
P
I
S
SF
N
DK
5