Decommissioning, Storage And Disposal; Temporary Decommissioning; Final Decommissioning; Storing The Device - HEYLO KS 35 T Betriebsanleitung

Oil heater KS 35 T
See also
 Contact to HEYLO GmbH
20 Decommissioning,
storage and disposal
The following principles apply for the decommission-
ing, storage and disposal of the device:
These tasks may only be carried out by trained and
authorized specialists.
DANGER
Danger to life due to electric shock
Touching electrically live parts can be fatal.
a) Switch off the device and pull out the mains
plug.
20.1 Decommissioning

Temporary decommissioning

a) Switch off the device at the device switch and
let the cooling time elapse.
b) Disconnect the power plug.
c) Empty the fuel tank and dispose of the fuel ac-
cording to the statutory regulations.
d) Clean the device (see Checking and cleaning
the device [ 39]).
 The device has now been temporarily decom-
missioned.

Final decommissioning

✓ Carry out all the steps needed for temporary
decommissioning.
a) Disconnect all the incoming and outgoing lines
(power supply lines).
 You have now taken the device permanently out
of service.
See also
 Contact to HEYLO GmbH
20.2

Storing the device

a) Before putting the device in storage, run it brief-
ly in heating mode with winter diesel to fill the
pipes with a frost-proof fuel.
b) Store the device in a dry place where it is pro-
tected against frost. Observe the prescribed
storage temperature range (see Technical data
and factory settings [
42 / 44
[ 26]
[ 26]
42]).
20.3

Disposal

The device is primarily made of recyclable materials.
If handled properly, it does not present a hazard to
the operator and the environment. However, opera-
tion of the device might produce waste containing
harmful and/or environmentally hazardous sub-
stances (air filters). These materials must be dis-
posed of properly according to the statutory regula-
tions.DisposalDevice
The individual components of the device (e.g.
pumps, metal components, etc.) must be taken to a
qualified disposal and recycling company. Commis-
sion a qualified, specialist company to dispose of
and recycle the device.
See also
 Contact to HEYLO GmbH
21 Technical data and
factory settings
Model
Prod. no.
Rated heat output [kW / BTU/h /
kcal/h]
Hot air volume flow at ∆p [m³/h]
Fuel autonomy [h]
Fuel consumption [kg/h]
Admissible fuels
At temperature below 5°C
Fuel tank capacity [l]
Power connection [V/Hz]
Power consumption [kW]
Current consumption [A]
Protection class [IP]
Weight (kg)
Length [mm]
Width [mm]
Height [mm]
Tab. 7: Technical data
Parameter
Oil pump pressure [bar]
Nozzle injection rate [US gal/h]
[ 26]
KS 35 T
2202603
34 / 116000 /
29200
1800
21
2.71
Diesel, petrol
Winter diesel
65
220-240 / 50
0.3
3.5
44
61
1200
575
1000
Value
12
0.65
EN