Control Panel - Panasonic EY4550 Bedienungsanleitung

Control Panel

(1)
(1) LED light
CAUTION:
• The built-in LED light is designed to
illuminate the
temporarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation
exposure.
(3)
(2)
Before the use of LED
light, always pull the
power switch once.
Press the LED
light button.
The light illuminates
with very low current,
and it does
adversely affect the
performance of the
driver during use or
its battery capacity.
small work
(2) Overheat warning lamp
Off
(normal
operation)
The overheating protection feature
halts operation to protect the battery
pack in the event of overheating. The
overheat warning lamp on the control
panel flashes when this feature is
active.
not • If the overheating protection feature
activates, allow the driver to cool
thoroughly (at least 30 minutes). The
battery is ready for use when the
overheat warning lamp goes out.
• Avoid using the driver in a way that
causes the overheating protection
feature to activate repeatedly.
area
(3) Battery low warning lamp
Off
(normal
operation)
Excessive (complete) discharging of
lithium ion batteries shortens their
service life dramatically. The tool
includes a battery protection feature
designed to prevent excessive dis-
charging of the battery pack.
• The
activates immediately before the
battery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warning
lamp flashing, charge the battery
pack immediately.
- 12 -
Flashing: Overheat
Indicates operation has
been halted due to
battery overheating.
Flashing
(No charge)
Battery protection
feature active
battery protection feature