Operation And Use - Concept VT 8010 Bedienungsanleitung

OPERATION AND USE

1. Place the unit on a stable surface or fl oor to prevent it from tipping over.
2. Connect the appliance to the power outlet.
3. The appliance emits a beep and the power indicator light (G) comes on and remains on as long as the appliance
is powered.
4. The appliance goes into OFF. If the display shows a blinking dot, it means that the tip over switch has been
activated.
5. Press the ON/OFF button (A) to turn on the appliance. It will begin to heat with the predefi ned settings.
Press the MODE button (E) to select one of the following functions available: Heating 1
ECO, Ventilation ( ), Anti-freeze ( ).
6.1 Ventilation ( ) In this operating mode only the fan operates, so the appliance does not heat the room.
6.2 Anti-freeze ( ) In this operating mode the appliance keeps the room at a temperature of 45°F (7°C)
to prevent freezing temperatures.
6.3 Heating 1 and Heating 2
Heating 1 (Min power)
The appliance operates at the minimum power, reducing noise and energy consumption to the minimum.
Heating 2 (Max power)
The appliance operates at the maximum power for rapid heating of the room.
6.4 The ECO function is available in Heating 1 and 2.
When this function is active, the appliance automatically sets the most appropriate power level to guarantee
optimum comfort while reducing energy consumption.
While the "ECO" function is active, the appliance may switch automatically to a lower heating power than the one
displayed.
6. If you want the appliance to distribute the airfl ow over a larger area, press the oscillation button (C)(
appliance will then oscillate right and left. To stop the oscillation in the desired position, just press oscillation
button (C) again.
7. To turn off the appliance press button ON /OFF (A). The display will show a countdown for about 6 seconds.
THERMOSTAT INSTRUCTIONS
1. Press the MODE button (E) until the Mode indicator lights in ECO mode.
2. To adjust set temperature, Press the button + to increase the desired temperature and the button - to decrease
the desired temperature.
3. When the air temperature reaches the set temperature, the heater will stop to heat at once and stop to blow after
25 seconds.
4. When the air temperature is below the set temperature, the heater will come back on.
NOTE:
The display can show the temperature in both °F and °C. To change the temperature scale, press and hold the + key
for a few seconds, then release.
Please be aware that as this display is for information purposes only and not a precision device. The displayed tem-
perature may slightly vary from the actual temperature.
It is normal for the heater to cycle ON and OFF as it maintains the set temperature.
When adjusting temperature, the set temperature on display will fl icker for 5 seconds. In 5 seconds, if no changes
are made, LED lights will stop fl ickering, display room temperature again.
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
28
EN
, Heating 2 ,
).The
VT 8010