Cleaning And Maintenance - Concept KS3006 Bedienungsanleitung

EN
8. Hang the appliance on the suspension hooks installed on the wall and screw the spacers into the bottom holes
(Fig. 7).
9. Make sure the appliance is firmly installed on the wall and there is no danger of its fall during operation.
CAUTION
When turning the appliance on for the first time or after a prolonged downtime, it may produce a slight smell. This
smell will vanish after a short time.
OPERATING INSTRUCTIONS
1. If you use the appliance as a free-standing unit, place it on a stable surface or floor to prevent it from overturning.
If the appliance is mounted on a wall, make sure that all flammable substances in its vicinity conform to the
minimum distance requirements.
2. Uncoil the supply cable completely.
3. Connect the power cord plug to the mains socket outlet.
4. Use the mode selector (4) to choose the power output 750, 1250 or 2000 W.
5. Use the thermostat regulator (3) to adjust the required room temperature. When 750, 1250 or 2000 W power
outputs are selected, the unit will alternately switch on and off, thus keeping the required temperature. You can
activate a fan with a switch (5) to rapidly reach the required room temperature.
Note: You can set a more accurate temperature in the following way:
Set the thermostat to a maximum value, then switch the unit to the heating mode (750, 1250 or 2000 W). When
the required room temperature is reached, turn the thermostat (3) slowly to a lower temperature until the unit
switches off.
6. After use, switch off the unit and unplug it from the mains outlet.

CLEANING AND MAINTENANCE

Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
KS3006
Fig. 7
29