Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the unit to an authorized service center for testing and repair.
• The unit is not designed for outdoor use.
• The unit is not designed for outdoor use.
• The unit is suitable for domestic use only. It is not designed for commercial operation.
• The unit is suitable for domestic use only. It is not designed for commercial operation.
• Do not touch the unit with wet or damp hands.
• Do not touch the unit with wet or damp hands.
• Do not immerse the power cord, plug, or appliance into water or any other liquid.
• Do not immerse the power cord, plug, or appliance into water or any other liquid.
• The unit shall not be mounted on the wall.
EN
• The unit shall not be mounted on the wall.
• The unit shall not be used in any means of transport.
• The unit shall not be used in any means of transport.
• Do not repair the appliance yourself. Contact an authorized service center.
• Do not repair the appliance yourself. Contact an authorized service center.
Failure to follow the manufacturer's instructions may cause refusal of warranty repair.
Failure to follow the manufacturer's instructions may cause refusal of warranty repair.
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliances by a person responsible for their safety.
concerning use of the appliances by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
2. Children should be supervised to ensure that they do not play with the appliance.
PRODUCT DESCRIPTION
• Do not use the unit if it does not operate properly, if it has been dropped, damaged or exposed to any liquids. Take
PRODUCT DESCRIPTION
the unit to an authorized service center for testing and repair.
1. Radiator sections
• The unit is not designed for outdoor use.
1. Radiator sections
2. Carrying handle
• The unit is suitable for domestic use only. It is not designed for commercial operation.
2. Carrying handle
3. Thermostat regulator
• Do not touch the unit with wet or damp hands.
3. Thermostat regulator
4. Mode selector
• Do not immerse the power cord, plug, or appliance into water or any other liquid.
4. Mode selector
• The unit shall not be mounted on the wall.
5. Supply cable holder
• The unit shall not be used in any means of transport.
5. Supply cable holder
6. Wheels
• Do not repair the appliance yourself. Contact an authorized service center.
6. Wheels
Failure to follow the manufacturer's instructions may cause refusal of warranty repair.
2
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliances by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
4
ASSEMBLY
PRODUCT DESCRIPTION
ASSEMBLY
3
It is necessary to fix the wheels on the bottom side prior to the first use.
1. Radiator sections
It is necessary to fix the wheels on the bottom side prior to the first use.
The unit shall not be used without properly installed wheels.
2. Carrying handle
The unit shall not be used without properly installed wheels.
3. Thermostat regulator
1. Place the unit on a stable surface (desk or floor).
5
1. Place the unit on a stable surface (desk or floor).
Check to make sure that the unit is undamaged, e.g. by fall or transport.
4. Mode selector
Check to make sure that the unit is undamaged, e.g. by fall or transport.
Do not use a damaged unit.
5. Supply cable holder
Do not use a damaged unit.
2. Screw the wheels in the bottom strips, and lace the curved end of the yoke in the opening in each strip (Fig. 1).
6. Wheels
2. Screw the wheels in the bottom strips, and lace the curved end of the yoke in the opening in each strip (Fig. 1).
3. Mount the set onto the bottom part of the unit (Figs. 2, 3).
3. Mount the set onto the bottom part of the unit (Figs. 2, 3).
4. Fasten the yoke using a winged nut (Fig. 4) in order to stabilize the unit and prevent it from turning over.
4. Fasten the yoke using a winged nut (Fig. 4) in order to stabilize the unit and prevent it from turning over.
26
32
26
32
ASSEMBLY
It is necessary to fix the wheels on the bottom side prior to the first use.
The unit shall not be used without properly installed wheels.
56
1. Place the unit on a stable surface (desk or floor).
2
2
3
3
4
4
5
5
1
6
6
1
RO 3107, RO 3109, RO 3111
RO 3207 | RO 3209 | RO 3211
RO 3107, RO 3109, RO 3111
RO 3207 | RO 3209 | RO 3211
6
6
RO3307 | RO3309 | RO3311
ASSEMBLY
It is necessary to fix the wheels on the bottom side prior to the first use.
The unit shall not be used without properly installed wheels.
1. Place the unit on a stable surface (desk or floor).
1.
Place the unit on a stable surface (desk or floor).
Check to make sure that the unit is undamaged, e.g. by fall or transport.
EN
Check to make sure that the unit is undamaged, e.g. by fall or transport.
Do not use a damaged unit.
Do not use a damaged unit.
2. Screw the wheels in the bottom strips, and lace the curved end of the yoke in the opening in each strip (Fig. 1).
2.
Place the slide assemblies on the chassis rails of the appliance and tighten them with wing
3. Mount the set onto the bottom part of the unit (Figs. 2, 3).
nuts so that the appliance is stable and there is no risk of it overturning.
4. Fasten the yoke using a winged nut (Fig. 4) in order to stabilize the unit and prevent it from turning over.
26
1
32
1
Fig. 1
NOTE
When turning the unit on for the first time or after prolonged downtime, the unit may release a slight smell. This smell
will vanish after a short time.
OPERATING INSTRUCTIONS
1. Place the unit on a stable surface or floor to avoid tipping over.
2. Uncoil the supply cable.
3. Connect the power cord plug to the wall outlet.
2
4. Select the required function using the mode selector (Fig. 5)
3
4
3 Mode selector
0 – Off.
1 = low heat
2 = medium heat
3 = full heating capacity
5. You may set the required temperature in the room using the thermostat regulator. When heating function 1, 2, or 3 is
selected, the unit will alternately switch on and off, thus keeping the required temperature.
5
Note: More accurate temperature can be set as follows:
Set the thermostat to maximum, and switch the heating to 1, 2, or 3. When the required temperature is reached in the
room, turn the thermostat slowly to a lower temperature, until the unit switches off.
6. After use, move the mode selector to the 0 position and unplug the unit from the mains.
CLEANING AND MAINTENANCE
RO3307 | RO3309 | RO3311
WARNING!
Fig. 2
Fig. 3
(Fig. 2)
RO3307
RO 3207
RO3309
RO 3209
RO 3211
RO3311
0 W
0 W
0 W
600 W
800 W
1000 W
900 W
1200 W
1300 W
1500 W
2000 W
2300 W
6
EN
EN
RO 3107, RO 3109, RO 3111
RO 3207 | RO 3209 | RO 3211
Fig. 4
Fig. 2
Fig. 5
57
Werbung
Inhaltsverzeichnis
