Cleaning And Maintenance - Concept KS3007 Bedienungsanleitung

EN
ASSEMBLY
The unit must not be used without properly installed legs.
a) Usage as a free-standing appliance
Before you start using the unit, attach the legs which increase its stability and enable the air to flow into the inlet grille.
1. Place the unit on a stable surface (e.g. table).
2. Attach the legs on the body.
3. Screw the legs firmly into the body (Fig. 1).
CAUTION
When turning the appliance on for the first time or after a prolonged downtime, it may produce a slight smell. This
smell will vanish after a short time.
OPERATING INSTRUCTIONS
1. Place the appliance on a stable surface or floor to prevent it from overturning.
2. Uncoil the supply cable completely.
3. Connect the power cord plug to the mains socket outlet.
4. Use the mode selector (4) to choose the power output 750, 1250 or 2000 W.
5. Use the thermostat regulator (3) to adjust the required room temperature. When 750, 1250 or 2000 W power
outputs are selected, the unit will alternately switch on and off, thus keeping the required temperature. You can
activate a fan with a switch (5) to rapidly reach the required room temperature.
Note: You can set a more accurate temperature in the following way:
Set the thermostat to a maximum value, then switch the unit to the heating mode (750, 1250 or 2000 W). When
the required room temperature is reached, turn the thermostat (3) slowly to a lower temperature until the unit
switches off.
6. After use, switch off the unit and unplug it from the mains outlet.

CLEANING AND MAINTENANCE

Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
KS3007
Fig. 1
19