Maintenance And Cleaning - Concept KS3004 Kurzanleitung

EN
1. Place the unit on a stable surface (e.g. desk).
2. Put the legs on the body of the unit.
3. Attach the legs to the body of the unit by tightening the bolts completely
(Fig. 1).
Caution
When turning the unit on for the first time or after prolonged downtime, the
unit may release a slight smell. This smell will vanish after a short time.
Operating Instructions
1. Place the unit on a stable surface or floor to avoid tipping over.
2. Uncoil the supply cable.
3. Connect the power cord plug to the wall outlet.
4. Select the required power output 750, 1250 or 2000 W using the mode
selector.
5. You may set the required temperature in the room using the thermostat
regulator. When heating function 750, 1250 or 2000 W is selected,
the unit will alternately switch on and off, thus keeping the required
temperature (Fig. 2).
Note: More accurate temperature can be set as follows:
Set the thermostat to maximum, and switch the unit to the heating
position (750, 1250 or 2000 W). When the required temperature is
reached in the room, turn the thermostat slowly to a lower temperature,
until the unit switches off.
6. After use, switch off the unit and unplug it from the mains.

MAINTENANCE AND CLEANING

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may
damage the unit's surface!
The air inlet and outlet grilles should be cleaned frequently to ensure proper operation of the unit and to avoid
overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
SERVICING
Any extensive maintenance or repair requiring access to the internal parts of the product shall be performed by an
authorized service center.
KS3004
Fig. 1
Fig. 2
19