Le Chai LM480 Bedienungsanleitung Seite 62

3 - Digital display of the temperature in the upper zone
4 - Digital display of the temperature in the lower zone
5 - Setting button for the upper zone
6 - Setting button for the lower zone
Starting the appliance
Press the start/stop button for about 3 seconds
Do the same to turn it off.
Temperature control
The internal temperature is regulated by the electronic thermostat controlled by the buttons inside the
appliance.
Each time the "upper zone" or "lower zone" key is pressed, the selected zone is incremented by one
degree. To obtain a temperature lower than the one indicated,
You can adjust the temperature degree by degree. The temperature is set using the arrows 5 or 6 on the
right of the temperature indicator.
After the temperature is selected, the display will flash for 5 seconds and display the set-point
temperature. If you want to know the actual temperature in the cellar, you must press the arrows 5 and 6
at the same time for 3 seconds; after 5 seconds, the set-point temperature will be displayed again.
NOTE: The default temperature is 6°C in the upper zone and 12°C in the lower zone.
NOTE: The range of temperature of this wine cellar is between 5°C and 10°C in the upper zone and
between 10°C and 18°C in the lower zone.
To avoid too much condensation when the ambient temperature is higher than 28°C, do not lower the
temperature below 7°C.
Control of the light
To turn on or off the internal light, press the button.
The (LED) light is suitable for the conservation of wine.
In order to reduce energy consumption, the LED light goes off automatically after 10 minutes. However,
we recommend turning off the light under normal use or after each use. However, if you wish to leave the
light on, the procedure is as follows; press button 2 for at least 5 seconds; the display will then show
"LP". After a few seconds, the display comes back to the temperature indication and the light stays on
continually. To return to the light turning off automatically after 10 minutes, press button 2 for at least 5
seconds; the display will then show "LF". After a few seconds, the display comes back to the
temperature indication and the light goes off automatically.

Note

If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine cooler will not start.
 When you use the Wine cooler for the first time or restart the Wine cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the Wine cooler is running for a few hours everything will be back to normal.
DEFROSTING
Defrosting of your wine cabinet is fully automatic. It requires no action on your part.
During operation, you may notice condensation drops forming on the rear inside wall of the cabinet. They
will be eliminated during automatic defrosting.
CARE OF YOUR CABINET
62