Le Chai LM480 Bedienungsanleitung Seite 61

Adjusting the temperature
Control panel of the LM 480
1
2
Starting the appliance
Press the start/stop button for about 3 seconds
Do the same to turn it off.
Temperature control
The internal temperature is regulated by the electronic thermostat controlled by the buttons inside the
appliance.
You can adjust the temperature degree by degree. The temperature is set using the arrows
on the right of the temperature indicator.
After the temperature is selected, the display will flash for 5 seconds and display the set-point
temperature. If you want to know the actual temperature in the cellar, you must press the arrows
at the same time for 3 seconds; after 5 seconds, the set-point temperature will be displayed again.
NOTE: The default temperature is 12°C
NOTE: Because of its construction, there is usually a difference in temperature (4° - 6°C) between the
top and the bottom of the wine cellar. We advise you to place the bottles requiring a lower temperature
(white wine, rosé or champagne) at the bottom.
The temperature range of this wine cellar is between 5°C and 18°C.
To avoid too much condensation when the ambient temperature is higher than 28°C, do not lower the
temperature below 7°C.
Control of the light
To turn on or off the internal light, press the button.
The (LED) light is suitable for the conservation of wine.
In order to reduce energy consumption, the LED light goes off automatically after 10 minutes. However,
we recommend turning off the light under normal use or after each use. However, if you wish to leave the
light on, the procedure is as follows; press button 2 for at least 5 seconds; the display will then show
"LP". After a few seconds, the display comes back to the temperature indication and the light stays on
continually. To return to the light turning off automatically after 10 minutes, press button 2 for at least 5
seconds; the display will then show "LF". After a few seconds, the display comes back to the
temperature indication and the light goes off automatically.
Control panel of the LB 445 / LBN 445
1 - Start/Stop button
2 - Light button
4
3
5
1
3
2
1 – ON/OFF button
2 – Light button
3 – Digital display of the temperature
4 – Setting button to increase temperature
5 – Setting button to decrease temperature
5
4
6
or or
and
61