Sebson GS559A Bedienungsanleitung Seite 16

For networking, you need at least two networked devices. Each device is provided with a code by the manufacturer.
There are a total of over 60,000 encodings. If one device is connected to another one, it will accept the code of the
other. An already networked device, which is to be connected to a new device, takes over the code of the new
device. Please note that devices may only be interlinked within an apartment or a family home!
1. Take a device that you want to network with another device and put it in the transmission mode. Press the
TEST button 3 times in succession. The LED lights up red for about 10 seconds continuously.
2. While the first device is in transmission mode for approximately 10 seconds (LED lights continuously red),
take another device and press the TEST button 3 times in succession. If a short beep sounds and the LED
flashes briefly, networking was successful.
3. In order to network additional devices with the first device, repeat steps 1 and 2 until all devices are
networked together.
4. Afterwards, check whether the devices are properly networked by carrying out a functional check. Press
and hold the TEST button on any networked device. If the alarm sounds on all networked devices while you
hold down the TEST button, the networking was successful. To stop the function check, release the TEST
button. The other devices stop beeping after a maximum of one minute.
on all devices, repeat the first two steps with the affected device, and repeat the function check.
5. If the function check is unsuccessful again, perform a RESET (see chapter RESET-Mode) of the device
and check the batteries. Then repeat the first two steps.
RESET-Mode:
In order to perform a RESET, proceed as follows:
1. Remove the batteries.
2. Press and hold the TEST button while reinserting the batteries. Pay attention to the correct polarity!
3. The LED lights solid red for about 3 seconds after inserting the batteries. Note: Keep and hold the TEST
button pressed!
4. When the LED light turns off, release the TEST button.
5. The LED light turns on. Press the TEST button again.The RESET process is completed by a short beep
sound.
Explanation of the LED modes :
LED flashes every 50 seconds:
LED flashes every second and alarm sounds:
Peep 0,5s –Pause 0,5s - Peep 0,5s – Pause 0,5s
- Peep 0,5s – Pause 1,5s LED flashes – repetition
of the signal:
Alarm sounds 2 x in quick succession and
after one second LED flashes (recurring
signal): Peep – Peep – Pause 1,2s – LED
flashes – repetition of the signal
LED flashes every second and alarm sounds:
Peep 0,2s – Pause 0,1s – LED flashes –
repetition of the signal:
LED flashes every 16 seconds:
LED flashes every 50 seconds and a short
alarm tone sounds:
The smoke alarm detector is working properly..
TEST button is pressed or the alarm has been triggered by
smoke. (Local smoke alarm signal)
TEST button is pressed or the alarm has been triggered by
smoke. (Radio alarm signal)
Alarm has been triggered by heat (local heat alarm signal)
The unit is in the silent mode
Batteries are low. Replace the batteries!
Attention:
If the alarm sounds not
16