Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Before Getting Started; Switching The Appliance On And Off; Setting The Temperature - hanseatic HKGK18560ENFI Gebrauchsanleitung

Kühl-gefrier-kombination
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operation

Before getting started

• Read chapter "Safety" from page EN-4 and
all the safety notices.
• Set up and connect the appliance as
described in chapter "Start-up" from
page EN-24.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
The appliance is switched on as soon as the
mains plug is plugged in.
The compressor starts to work, the refrigerant
flows through the pipes and a quiet humming
sound can be heard.
The indicators on the control panel illuminate
for 3 seconds.
If the appliance is making unusual
noises, check that it is stable and re-
move any objects that may be on top
of it.
Switching off
• To switch the appliance off, pull the mains
plug out of the socket.
Operation
If the appliance is switched off, leave
the doors open slightly to avoid mould
formation.

Setting the temperature

CAUTION
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. The
temperature may increase in the fridge
and freezer which may cause the foods
stored within to spoil more quickly.
■ Always ensure the prescribed ambi-
ent temperature is maintained (see
"Intended use" on page EN-4).
If you set a lower temperature, you will
require greater refrigeration perfor-
mance. This increases energy con-
sumption.
Switching on for the first time
When the appliance is switched on the first
time, the standard temperature setting is
+5 °C for the fridge and –18 °C for the freezer.
All indicators on the display will also illumi-
nate for a couple of seconds; the control pan-
el is locked.
Locking/unlocking the control
panel
• To unlock the control panel, press the but-
ton (22) for 3 seconds. The "Button lock
active" indicator (19) will disappear, a beep
will sound and the control panel will unlock.
• To lock the control panel, press the but-
ton (22) for 3 seconds. The "Button lock
Page EN-13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis