Klarstein Basel Illumine Bedienungsanleitung Seite 23

• Gently bring the heater level with the wall.
• Mark the two bottom holes position (see Fig. 5).
Figure 5
• Remove the heater ensuring that the bottom fixing bracket is rotated up.
• Drill and fit the wall plugs.
• Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down
again and use the screws provided to permanently fix the heater in place.
• Unpack the log from the bag and place them along the light unit in the desired
position (see figure 10).
• Place the front glass panel over the front of the heater aligning the hooks at each
side of the glass panel with the slots at each side of the heater body (see Fig. 4).
Then slide down the glass panel in place. Two people will be required for this
operation.
• Insert and tighten the front glass panel screw (see Fig. 6) to secure the front glass
panel to the heater.
Figure 6
EN
23