Cleaning And Maintenance - Klarstein Basel Illumine Bedienungsanleitung

(5) Set temperature:
• Then press the [TIMER SET] button, and the temperature set starts blinking. At this
moment, the temperature displayed is normally the set temperature, which can be
adjusted by pressing the [+] or [-] button.
(6) Save setting:
• Press [TIMER SET] button to continue with the setting, and press [OK] button to
complete the setting .
Timer switch
• [TIMER ON/OFF] is to control the timed opening and closing.
• Restart the machine after power is cut off, the original setting is kept, but the current
date and time must be reset.
Notes on the week timer:
1 When the week timer is power on, you should turn on the heating function, or
else when the machine is working again, there will be only the flame effect
working.
2 Repeat the same procedures to set more timing cycles if required after the 01
timing cycle is finished.
3 When the week timer setting is finished, "TIMER ON/OFF" function can be
effective.

CLEANING AND MAINTENANCE

• Always switch off the appliance and disconnect from the mains supply before
cleaning heater.
• For general cleaning use a soft clean duster.
• Never use harsh abrasive or cleaners.
• The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use
proprietary glass cleaners.
This product does not use a standard bulb for its flame effect. The appliance uses an
electronically controlled LED system to create the effect, therefor no parts need to be
replaced. There are no user-serviceable parts on this appliance. Under no circumstances
should the appliance be serviced be anyone other than a qualified electrician.
EN
29