Display; Error Codes - SoFlow SO3 Originalbetriebsanleitung

You can operate the front disc brake and the electronic rear brake by using the brake lever on the left side of the handlebars. Shift your body weight slightly to the rear to compensate for the
braking effect of the brake. This allows safe and controlled braking. Always be careful when using the brake. Pull the brake lever firmly to stop SO3 completely.

4.2 Display

You will find the following information on the display:

Light

Speed

Bluethooth

km absolut

4.3 Error codes

The control electronics of your SO3 continuously check the correct function of all important components. If your SO3 detects a malfunction, this is indicated on the display:
Error message

E1: Communication failure

E2: Error with the brake

E3: Error with the transfer handles

E5: Error with the control
Stop using SO3 immediately if the display shows one of these error messages. Switch the unit off and on again. Check the plug connection between the handlebars and the front bar that no dirt
will affect the contacts of the plugs. Make sure that the battery is fully charged. If the error message still persists, contact the SoFlow service at info@soflow.com.
copyright by www.soflow.com 14