Settings - Electrolux GA60LVCN Benutzerinformation

8 www.electrolux.com
Programme
P2
AUTO
P3
70° Pro
P4
45° Gläser
P5
30 Minuten
P6
Extra SILENT
1) The pressure and the temperature of the water, the variations of the mains supply, the op-
tions and the quantity of dishes can change the values.
5.2 Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

6. SETTINGS

6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
• The activation or the deactivation of the
• The activation or deactivation of the
• The level of rinse aid according to the
These settings will be saved until you
change them again.
Downloaded from www.Manualslib.com
1)
according to the water hardness.
acoustic signal for end of programme.
rinse aid dispenser.
required dosage.
manuals search engine
Water
(l)
7 - 14 0.6 - 1.4
12.5 - 14.5 1.4 - 1.6
12 - 14 0.7 - 0.9
10
9 - 10 1.0 - 1.2
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
When you activate the appliance, usually it
is in programme selection mode.
However, if this does not happen, you can
set the programme selection mode in the
following way:
Press and hold Reset until the appliance
is in programme selection mode.
6.2 The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
Energy Duration
(kWh) (min)
40 - 150
154 - 164
75 - 85
0.9
219 - 229
30