Options; Before First Use - Electrolux GA60LVCN Benutzerinformation

is deactivated but it is possible to activate
it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and

7. OPTIONS

7.1 XtraDry
Activate this option when you want to
boost the drying performance. With the
use of this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
The option XtraDry is not a permanent
option and must be selected at every
cycle.
How to activate XtraDry
Press
The related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not

8. BEFORE FIRST USE

1. Make sure that the current level of
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
Downloaded from www.Manualslib.com
hold simultaneously
the indicators , ,
start to flash and the display is blank.
Desired options must be
activated every time before
you start a programme
(except for Multitab).
It is not possible to activate or
deactivate options while a
programme is running.
.
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
manuals search engine
2. Press
• The indicators
• The indicator
• The display shows the current
3. Press
= Acoustic signal on.
and until
4. Press the on/off button to confirm the
and
setting.
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
7.2 TimeSaver
This option increases the pressure and the
temperature of the water. The washing
and the drying phases are shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
How to activate TimeSaver
Press
If the option is not applicable to the
programme, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener. It
ENGLISH
, and
off.
continues to
flash.
setting: = Acoustic signal off.
to change the setting.
, the related indicator comes on.
11
go