Benelli Tornado Naked TNT125 Bedienungsanleitung Seite 139

Periodic maintenance and adjustment
8. Install the engine oil drain bolt and its
new gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
EN
Engine oil drain bolt:
25 N·m
6
9. Refill with the specified amount of the
recommended engine oil, and then install
and tighten the oil filler cap.
Recommended engine oil:
API SH, SAE10W-40, JASO MA
Oil quantity:
Oil change:
0.9L
With oil filter removal:
1.1L
TIP
Be sure to wipe off spilled oil on any parts
after the engine and exhaust system have
cooled down.
NOTICE
• In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not mix
any chemical additives. Do not
use oils with a diesel specification
of "CD" or oils of a higher quality
than specified. In addition, do not
use oils labeled "ENERGY CONSER-
VING II" or higher.
• Make sure that no foreign mate-
rial enters the crankcase.
10. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage.
If oil is leaking, immediately turn the engi-
ne off and check for the cause.
TIP
After the engine is started, the engine oil
level warning light should go off if the oil
level is sufficient.
6 - 12