Benelli Tornado Naked TNT125 Bedienungsanleitung Seite 138

To change the engine oil (with or wi-
thout oil filter cartridge replacement)
1. Place the vehicle on a lat surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Place an oil pan under the engine to col-
lect the used oil.
4. Remove the engine oil filler cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1 2
1. Engine oil drain bolt.
2. Gasket.
TIP
Skip steps 5–7 if the oil filter cartridge is
not being replaced.
5. Remove the cartridge of oil filter by re-
moving the screws and the relative cover.
2
1. Screws
2. Oil filter Cartridge cover
6. Apply a thin coat of clean engine oil to
the O-ring of the new oil filter cartridge.
6 - 11
Periodic maintenance and adjustment
TIP
1
Make sure that the O-ring is properly se-
ated.
7. Install the new oil filter cartridge, the
cover and the relative screws, and tighten
them to the specified torque.
Tightening torque:
Oil filter cartridge:
10 N·m
EN
6