Endress+Hauser iTEMP TMT84 Kurzanleitung Seite 31

TMT84
Item B
Procedure:
1. Open the cover (1) of the field housing (5).
2. Guide the mounting screws (2) through the lateral bores of the head transmitter (3).
3. Screw the head transmitter to the field housing.
4. When wiring is complete (see Section 4), screw the field housing cover (1) back on.
Item C
Procedure:
1. Press the DIN rail clip (4) onto the top-hat rail (5) until it engages.
2. Fit the mounting springs onto the mounting screws (1) and guide them through the lateral bores of the head
transmitter (2). Then fix both mounting screws in position with the circlips (3).
3. Screw the head transmitter (2) to the DIN rail clip (4).
Mounting bracket for wall mounting (wall mounting set available as accessory)
Endress+Hauser
Mounting in a field housing
Mounting on top-hat rail (top-hat rail as per IEC 60715)
1 4
0 m
( 5
m
. 5 1
i n )
2 1
m m
( 0
. 8 3
i n )
1 2
0 m
( 4
m
. 7 2
i n )
Installation instructions
6.5 mm
(0.25 in)
A0024604
31