Hitachi dv 20vc Bedienungsanleitung Seite 8

English
(2) Return the brush holders and other parts to their
original positions, as illustrated in Fig. 11.
(3) Place the lead wires in the specified position.
Be very careful not to allow the lead wires to
contact the armature or rotating parts of the motor.
(4) Mount the handle cover, while being careful to
ensure it does not pinch the lead wires, and secure
it firmly with the three screws.
CAUTION
Should the lead wire be pinched by the handle
cover or come in contact with the armature or
rotating parts of the motor, a serious danger of
electric shock to the operator will be created. Exercise
extreme caution in disassembling and reassembling
the motor, follow the above procedure exactly.
DO NOT attempt to disassemble any parts other
than those necessary to effect replacement of the
carbon brushes.
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
Repair, modification and inspection of Hitachi Power
Tools must be carried out by an Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.
MODIFICATION
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
NOTE
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
IMPORTANT
Correct connection of the plug
The wires of the mains lead are coloured in accordance
with the following code:
Blue:- Neutral
Brown:- Live
As the colours of the wires in the mains lead of this tool
may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black.
The wire coloured brown must be connected to the
terminal marked with the letter L or coloured red.
Neither core must be connected to the earth terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except United Kingdom.
7
Information concerning airborne noise and vibration
The measured values were determined according to
EN50144.
The typical A-weighted sound pressure level: 99 dB (A).
The typical A-weighted sound power level: 112 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
2
value: 14.5 m/s .