Starting/Stopping The Data Logger; Viewing The Logger Data; Deleting The Logger Data - Knick Portavo 908 Multi Betriebsanleitung

Data Logger

Starting/Stopping the Data Logger

With the data logger activated, automatic switch-off is disabled. Every time the
meter has been switched off, the data logger must be restarted.
Depending on the assignment of the right softkey (see "Configuration", page 14)
you can start/stop the data logger as follows:
Right softkey
Start/Stop logger
Hold value

Viewing the Logger Data

In the "Data logger" menu you can view the recorded entries either individually or as
curve characteristic (see examples).
You can also use the Paraly SW 112 software for managing the data logger.
1) Press Menu softkey.
2) Select "Data logger" using the arrows and confirm by pressing enter.
3) Select "View logger data" using the arrows and confirm by pressing enter.
4) Select filter ("Meas.point" or "Time + Meas.point" or "All values").
5) Select the parameter corresponding to the sensor.
6) Press Menu softkey.
7) Select the desired entries using the arrow (see example 1).
8) For display as curve characteristic, press Graphic softkey.
You can use the arrows to navigate between entries (see example 2).

Deleting the Logger Data

To delete the recorded entries, proceed as follows:
1) Press Menu softkey.
2) Select "Data logger" using the arrows and confirm by pressing enter.
3) Select "Delete logger data" using the arrows and confirm by pressing enter.
4) Select deletion mode: "Complete", "Data", "Meas.point" or "Filter"
(you can filter for measuring point, parameter or time).
5) Press Delete softkey. The data are deleted according to the configuration.
6) Press Back softkey to return to menu selection.
1) Press right softkey Start logger / Stop logger.
1) Press Menu softkey.
2) Select "Data logger" using the arrows and confirm by
pressing enter.
3) Press Start or Stop softkey, resp.
pH ORP
39
Oxy Cond