Conductivity Configuration - Knick Portavo 908 Multi Betriebsanleitung

18
Cond

Conductivity Configuration

1) In measuring mode, press the Menu softkey.
2) Select "Configuration" and confirm by pressing enter.
3) Make the desired adjustments.
The following table gives you an overview.
Factory settings are shown in bold print.
"Conductivity Configuration" menu selection – part 1
Language
Auto-off
Temperature
Right softkey
+ Cond sensor
Conductivity
Range selection
Compensation
TC comp.
TC of solution
Ref. temp
TDS factor
Solution
* "+" indicates that submenus can be opened by pressing enter.
Deutsch | English | Español | Italiano | Français
Português | Русский
Off | 5 min | 10 min | 30 min | 60 min
°C | °F
Logger Start/Stop | Hold value | Print
*
S/cm | S/m
Auto | o.ooo µS/cm | oo.oo µS/cm |
ooo.o µS/cm | oooo µS/cm |
oo.oo mS/cm | ooo.o mS/cm | oooo mS/cm
Off | MΩ cm | TC | SAL | TDS | % by wt
TC: Linear | NLF | NaCl | HCl | NH3 | NaOH
TC: 0 ... 20.0 %/K | 2.1 %/K
TC: 0 ... 100.0 °C | 25 °C
TDS: 0 ...9.99 | 1.00
% by wt: NaCl | HCl | NaOH | H2SO4 | HNO3
Configuration
32 ... 212 °F | 77 °F
|